Orders >$15 will ship with full tracking from the US to domestic destinations and USPS ePacket countries (most of Europe, Brazil, Russia, Japan, South Korea, Singapore, Hong Kong, Israel, Australia, New Zealand).

Shared boards by: danil5

Search shared boards:
Raspberry Pi gateway interface

Raspberry Pi gateway interface

Created by danil5 on 2019-05-27 02:35:42

2 Layer Board - 1.0500 sq in (1.4000in x 0.7500in) / 677.42 sq/mm (35.56mm x 19.05mm)
$4.20 per set of 4 ($4.00 per sq in)

License: CC-BY 4.0

Say "Thank You"



Order Now

Top View - Complete Board

Top View - Complete Board

This is what your finished board will look like from the top.

Bottom View - Complete Board

Bottom View - Complete Board

This is what your finished board will look like from the bottom.

Raspberry Pi2 GPIO interface for NRF24L01+

Raspberry Pi2 GPIO interface for NRF24L01+

Created by danil5 on 2017-12-07 05:16:31

2 Layer Board - 0.4400 sq in (0.5500in x 0.8000in) / 283.87 sq/mm (13.97mm x 20.32mm)
$1.76 per set of 4 ($4.00 per sq in)

This small GPIO interface board allows using the NRF24L01+ radio (standard version with PCB antenna or external antenna with power amplifier) on a Raspberry PI GPIO interface.

I use this as my controller running Domoticz and it interfaces with the MySensor network via software also running on the Raspberry Pi2.

There is a small solder jumper on the bottom side.

If the middle contact and the contact marked with 3V3 are bridged, then 3V3 DC is taken from the GPIO via the 2x4 GPIO header. Use this setup when plugging the small standard radio's.

If the middle and 5V contacts of the jumper are bridged, then you need to add a two wire to connect the 1x2 pin male header to the two 5V pins of the GPIO. This second case is because the 3V3 pin on the GPIO can not carry enough power for the larger NRF24L01+ modules with power amplifier. So this board then takes power from the 5V input and steps that down to 3V3.

On the software side, install the Raspberry Mysensors gateway as per instructions below.

License: CERN Open Hardware License
Project URL: https://www.openhardware.io/view/17/Raspberry-Pi2-GPIO-interface-for-NRF24L01

Say "Thank You"



Order Now

Top View - Complete Board

Top View - Complete Board

This is what your finished board will look like from the top.

Bottom View - Complete Board

Bottom View - Complete Board

This is what your finished board will look like from the bottom.