Power Supply Adapter
Tested, works fine.
A power supply connector for Eurorack modular synthesizer connected to a block of screw terminals, so you can:
Also, there are some LEDs to indicate when power is present.License: CC-BY-SA 4.0
ESP12 Breadboard to Pogo Pin Adapter. Pogo pin holes are 1.14mm, so they should accept 1mm diameter pogo pins. Outer holes accept 3mm screws in case you want to sandwich two PCBs together for stability.License: CC-BY 4.0
SOIC8 to DIP8 adapter boardLicense: CC-BY 4.0
Advanced protoboard layout with 1.27mm pitch for smd parts from electroniceel on github.
Licensed under Creative Commons Attribution 4.0 International License
This tiny little board provides two FTDI-compatible 6-pin 0.1" headers, with the VCC and GND (power and ground) pins from each header linked to the corresponding pin on the other header, and the TX and RX (transmit and receive) pins crossed over.License: CC-BY-SA 4.0
A simple S08 to DIP8 Adapter board right? Well, there are actually a few nice features here that others lack. The 4-pin male headers are actually lock headers so the 4 male pins will be perfectly flush with the board; no need to tape or use a breadboard to solder this. Also, the pads for the S08 are extra long to make soldering by hand easier. The board shape itself makes it easy to identify pin 1 since the square corner with the square pad corresponds to pin1 of the S08 itself. The remaining pins are connected in the same order as the S08 pins are numbered and a little bit of top silk makes it easy to see where pins 4, 5, and 8 are. Finally, because of the lock header, this board is just a teensy bit smaller and less expensive than the other S08 to DIP8 board here.License: CC-BY 4.0
N/P-MOSFET breadboard adapterLicense: GNU GPL v.3
D2PAK regulator boardLicense: CC-BY 4.0
Teensy 3.6<->3.2 Adapter BoardLicense: CC-BY 4.0